Concrete Contractors in Brookside, CO

Brookside is a small statutory town in Fremont County, entered from the east on State Highway 115, and its homeowners look for concrete contractors for the same practical jobs as their neighbors in Cañon City. The town was incorporated in 1913 and covers just under half a square mile at 5,348 feet. It had 233 residents in 2010 and 236 in 2020, a steady, settled community.

Neighbors and setting

Brookside sits next to Lincoln Park, which borders it to the northwest, and it uses the Cañon City post office (ZIP 81212). A Brookside post office ran from 1888 until 1909. The town is part of the Cañon City micropolitan area, so it shares the Arkansas Valley's mild-but-freezing winters, sunny days and dry air.

Climate facts that matter for concrete

Nearby Cañon City averages about 38 inches of snow and 13.7 inches of precipitation a year, with January lows near 18 degrees and highs near 49. That means the ground freezes at night and thaws in the afternoon for much of the winter. Each cycle pushes water into cracks and joints. For Brookside slabs we use:

• Air-entrained concrete.
• Control joints at proper spacing and depth.
• Sealed joints and a penetrating sealer once cured.
• A broom finish on outdoor walking surfaces.

Get a Free Estimate

What homeowners here ask for

Driveways: replacing cracked or gravel drives with a full slab. Patios: plain or stamped, with a slope that carries water away. Walkways and steps: leading from the street to the front door. Slabs: for sheds, garages and hot tubs. Repairs: crack sealing, resurfacing and section replacement.

Hot tub and patio planning

A hot tub is one of the more common patio add-ons in a dry, sunny climate. A filled tub with people in it can weigh several thousand pounds, so it needs a slab built for the load: at least 4 inches thick, reinforced, on a compacted base, and level so the tub sits evenly. We extend the slab past the tub footprint so there is room to step in and out and to service the equipment.

Plan the electrical before the pour. A sleeve under the slab for the power line is easy to set while the forms are open and saves cutting concrete later.

Around the tub, use a textured finish or add grit to the sealer. Wet concrete near a tub gets slick, especially on a cold night.

Walks that drain

A front walk should slope slightly to one side, roughly a quarter inch per foot, so rain and snowmelt leave the surface. A flat walk holds water that freezes into a thin, slick sheet overnight. We check grades with a level during forming so the finished walk sheds water every time.

What happens after the pour

We remove forms after a day or two, backfill the edges and clean up. You get written care notes covering foot traffic, vehicle traffic and sealing.

Ask us to mark the joint layout on the forms before the pour if you want to see exactly where the lines will fall on your finished patio or walk.

Small town, short trip

Brookside sits next to Lincoln Park and Cañon City, so we often schedule work here alongside other Fremont County jobs. Small projects like a single walk or step replacement are welcome.

Base and drainage first

The Colorado Geological Survey describes swelling clay as a common and sometimes serious problem in Colorado and says cracked sidewalks, patios and driveways are typical signs. Much of that damage starts with water getting under a slab. We start every Brookside job by checking drainage and preparing a compacted granular base, then pour concrete that fits how you use the space. We check the Town of Brookside's permit rules before scheduling.